Harman JBL IRX ONE - Page 9

9
4. Connect the female end of the power cable to the IRX ONE and plug the male end into a wall socket.
AC Power Receptacle
& Power Switch
IRX ONE_Artwork Mixer Panel Design: Yanyang Jia Date: 2023-06-29 Units: mm M 1:1
Only for QSG
IRX ONE_Artwork
Mixer Panel
Design: Yanyang Jia
Date: 2023-06-29
Units: mm
M 1:1
Only for QSG
5. Turn the MAIN VOLUME and CHANNEL VOLUME controls all the way to the left.
Main Volume
Channel Volumes
IRX ONE_Artwork
Mixer Panel
Design: Yanyang Jia
Date: 2023-06-29
Units: mm
M 1:1
Only for QSG
6. Make audio connections.
1. Set the EQ Preset based on your application.
2. Adjust the individual gain levels for each connected input. Microphone inputs will be near the 3 o’clock position, and line
source will be near 9 o’clock. If using condenser mics, connect to CH1 and/or CH2, and push the PHANTOM button. See
“Phantom Power Disclaimer” on page 10 for important information about using phantom power.
Audio Connectors
Input Gain Levels
Phantom Power
IRX ONE_Artwork
Mixer Panel
Design: Yanyang Jia
Date: 2023-06-29
Units: mm
M 1:1
Only for QSG
IRX ONE_Artwork
Mixer Panel
Design: Yanyang Jia
Date: 2023-06-29
Units: mm
M 1:1
Only for QSG