Why is my Harman speaker signal distorted and loud with the PEAK light on?
The signal may sound distorted and very loud, and the PEAK light might be frequently lit because the input signal is too high, exceeding what the Harman speakers can handle. To resolve this, reduce the output level from the source, lower the level controls on the speaker, or consider using additional VE speakers.
Why is my Harman speaker signal distorted at moderate volumes?
If the signal from your Harman speaker sounds distorted even at moderate volumes and the LIMIT light is not lit, the mixer or another source might be overdriven. Consult the owner’s manual for your mixer to adjust controls such as input sensitivity (gain), channel faders, and master faders. Then, review the instructions in the Quick Start section of this guide.
How to fix hum or buzz in Harman speakers that changes with mixer level?
If you hear a hum or buzz from your Harman speakers that increases or decreases when the mixer level controls are moved, it could be due to an improper A/C ground or faulty equipment connected to the mixer input, or a faulty cable between the source equipment and mixer. Try disconnecting or muting channels one at a time to isolate the problem. Also, substitute a known-good cable for the suspected faulty cable. Refer to the owner’s manual of the faulty equipment for troubleshooting help.
General| Amplifier Class | Class D |
|---|---|
| Type | Powered Speaker |
| LF Driver | 10-inch |
| HF Driver | 1-inch |
| Inputs | 2 x XLR/TRS Combo |
| Outputs | 1 x XLR |
| Bluetooth | Yes |
To Next Page