15
10 AUX OPERATION
1. Connect one end of the audio cable to the AUX IN jacks on the back of the CUBE Wall
Mount Stereo.
2. Connect the other end of the audio cable to the LINE OUT jacks on the TV / DVD player,
etc.
3. Power ON the unit.
4. Press the
button repeatedly until "AUX" appears on the display.
5. Or press AUX button on the Remote Control.
6. Play the audio in the external device.
NOTE:
You can also use a 3.5mm to RCA cable instead of RCA to RCA cable to connect the external
player such as iPod, smartphone, MP3 player. (Insert the 3.5mm end of the cable into the Line
out/Aux out/Earphone jack on the player)
Before connecting, disconnect power.
1. Connect one end of optical connection cable (not supplied) to the OPTICAL IN jack on the
rear of the CUBE Wall Mount Stereo.
2. Connect the other end to the OPTICAL OUT jack on TV Back panel.
3. Power ON the unit.
4. Press the
button repeatedly until "OPTICAL" appears on the display. Or press OPT
button on the Remote Control.
5. Play the audio in the external device as usual and set the desired volume.
Note:
If there is no audio output (only picture) or noise when your TV or DVD player is connected to
the CUBE, please check DVD player or TV audio setting, and set the Digital Audio Output to
"PCM" format.
11 OPTICAL IN OPERATION
To Next Page
Loading...
