11
REMOTE CONTROL BATTERY INSTALLATION
1. Slide and lift the battery door.
2. Install 2 (two) AAA size batteries into the battery compartment as indicated by the polarity
markings.
3. Replace the battery door.
Battery Precautions:
Follow these precautions when using a battery in this device:
1. Use only the size and type of battery specied.
2. Be sure to follow the correct polarity when installing the battery as indicated in the battery
compartment. A reversed battery may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries
with fresh ones.
4. If the batteries in the device are consumed or the device will not be used for a long period of
time, remove the batteries to prevent damage or injury from possible battery leakage.
5. Do not try to recharge the battery not intended to be recharged; it can overheat and rupture.(Follow
battery manufacturer's directions.)
6. Do not dispose of battery in re. Battery may explode or leak.
7. Clean the battery contacts and those of the device prior to battery installation.
Note:
1. When there is an obstacle between the unit and the Remote Control, the Remote Control may not
operate.
2. When direct sunlight, an incandescent lamp, uorescent lamp or any other strong light shines on
the remote sensor of the unit, the remote operation may be unstable.
REMOTE CONTROL WORKING RANGE
To Next Page
Loading...
