3
www.jbl.com
English
PLACEMENT
For the best results, place the speakers 6 – 10 feet (1.8m – 3m) apart. Angling the speakers toward the listening
position can improve the stereo imaging. The speakers will produce the most accurate stereo soundstage when the
angle between the listener and the speakers is between 40 and 60 degrees.
6 – 10 ft
(1.8m – 3m)
40° – 60°
>20 in
(>51cm)
Generally, bass output will increase as the speaker is moved closer to a wall or corner.
For the best performance, we recommend that you place the speakers at least 20 inches (51cm) away from the side walls.
Keyholes
Keyholes
We have designed the Studio 610 speakers to mount directly onto a wall. Each speaker has four keyholes on the back
and will require four 4.0x38mm wood screws fastened to a wall stud. If a wall stud is unavailable, install an anchor
appropriate for a 4.0x38mm screw.
NOTE: You are responsible for the correct selection and use of mounting hardware (available through hardware stores)
that will ensure the proper and safe wall-mounting of the speakers. 4.0x38mm wood screws not provided.
1) Using the included wall brackets, mark the positions on the wall where you would like to place the mounting screws.
2) Fasten four 4.0x38mm wood screws to the wall using the markings from Step 1 as your guide. Leave an 1/16”
(1.59mm) space between the wall and screwhead. If a wall stud is not available, use an appropriate anchor.
3) Place the speaker on the wall by aligning the keyholes on the back of the speaker to the screwheads on the wall.
Once positioned properly, the speaker should slide down slightly and become secure.
STUDIO 698/STUDIO 690/STUDIO 680 – LEFT AND RIGHT CHANNELS
WALL MOUNTING THE STUDIO 610