EasyManuals Logo

Harman P43 User Manual

Harman P43
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
19
P43 Pellet Stove
The P43 Pellet Stove is capable of manual operation. This also allows the operator
to manually control operation during an emergency (i.e. igniter failure, when using a
502H battery backup, as opposed to the 512H, or when using certain generators.)
The unit can be switched between "AUTO" and "MANUAL" at any time during op-
eration.


The re will have to be lit with starting gel and a
match, or started automatically, see "Automatic Opera-
tion" on Page 16. Turn to "Manual" position when the
ignition cycle has started.
The difference between "AUTO" Room Temperature
Mode and "Manual" Room Temperature Mode is that
the re will not go out as the room temperature goes
above the control board setting. The unit can only go to
low burn and will remain there until it runs out of fuel or
until more heat is needed and the feed rate increases.
Feed rate adjustments and dial settings are the same
as "AUTO" settings.
The blower will shut off com-
pletely if the temperature on the ESP is too low.


The advantage of this mode is to allow the operator
to have a large viewing re without blowing extra heat
into the room.
During operation, with the temperature dial set at
#5 or less, the distribution fan will not operate. A #5 on
the temperature dial and a #5 on the feed adjuster is
approximately 80% output. It is not necessary to oper-
ate the distribution blower below this point. This control
setting allows a higher burn rate (a larger viewing re)
without an excess of hot air blowing into the room.
An example of when to use the Manual Stove Tem-
perature Mode is if you want to watch a large re and
the room is already up to temperature. The Stove
Temperature Mode allows you to have a larger re and
a lower sound level, without the distribution blower.







      
        


This setting will produce a large viewing re
without a distribution blower operating.

   This
setting, see below, will produce a
room temperature of 70 degrees
with the distribution blower at
medium speed.

Other manuals for Harman P43

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Harman P43 and is the answer not in the manual?

Harman P43 Specifications

General IconGeneral
Fuel TypePellet
IgnitionAutomatic
ThermostatYes
Heating AreaUp to 2, 200 sq ft
BlowerYes
WarrantyLimited

Related product manuals