22
P43 Pellet Stove
Whenever wood is burned slowly, the potential exists for creosote
to form in the venting. The chimney or venting system should be
inspected periodically throughout the heating season to determine if
a creosote buildup has ocurred. If a signicant layer of creosote has
accumulated (3mm or more), it should be removed to reduce the risk
of a chimney re. A professional chimney sweep is recommended,
since they would normally have the correct equipment to ensure
proper creosote removal.
turn the stove to
"OFF" to allow the unit to shut down. Call the re department, and be
sure everyone is out of the residence. Before re-using the appliance,
have the venting system thoroughly inspected and replace any
damaged components.
The glass in your Harman stove is a special ceramic glass.
abuse the glass by striking or slamming the door.
burn the appliance if the door glass is cracked or broken.
• Replace with Harman supplied glass.
Soot and/or y-ash may accumulate on
the viewing glass, and will ocassionally
need to be cleaned. Clean the glass
with a soft cloth and mild glass cleaner.
clean the glass when hot,
and avoid the use of abrasive clean-
ers.
remove all remaining glass
and gasket materials prior to replacing
the glass.
Lay the door face down on a at
surface. Remove the glass retainers
and screws. Apply the gasket material
to the face of the new glass. Lay the
glass into the door, making sure that
the glass is contained within the chan-
nels and raised areas of the door itself.
Lay the glass retainers into position
and install the screws. Tighten each
screw evenly to avoid making any
stress points.
Retainers and screws
Glass
Adhesive gasket
Door Frame
To Next Page
Loading...
