Harman P61A - Page 11

11
P 6 1 A P ellet S tove
3 -9 0 -0 5 8 2 2 R 2 8 _ 0 8 /1 3
# 4 Installing into an ex isting chimney
This method provides excellent venting for normal operation.
This method also provides natural draft in the event of a
power failure. If the chimney condition is questionable you
may want to install a liner as in method #7.
In some places in the US and Canada it is required that the
vent pipe extend all the way to the top of the chimney.
The chimney should be inspected and cleaned before
installing your stove. If you discover that the chimney does
not have a clay tile liner or has cracks or aking of the tile
liner you will need to install a stainless steel liner within
the chimney. In most cases the inside diameter of this liner
should be . Either exible or rigid liner may be used for
this purpose. Refer to ethod   7.
Be sure to design the venting so that it can be easily cleaned.
5 ntan nt an etn repace cmney
This method provides excellent venting for normal operation.
This method also provides natural draft in the event of a
power failure. If the chimney condition is questionable you
may want to install a liner as in method #.
In some places in the US and Canada it is required that the
vent pipe extend all the way to the top of the chimney.
The chimney must be inspected and cleaned before
installing your stove. If you discover that the chimney does
not have a clay tile liner or has cracks or aking of the tile
liner you will need to install a stainless steel liner within the
chimney, as shown in ethod   7.
The chimney must be sealed at the damper using a steel
plate. aowool, mineral wool or other non-combustible
insulation is recommended above the plate to reduce the
possibility of condensation. The connector pipe should
extend through the smoke chamber to the base or into the
rst ue tile.
Be sure to design the venting so that it can be easily cleaned.
F ig. 1 0
F ig. 1 1
V enting