Harman PC45 - Venting into Existing Chimneys (cont.); Methods #5 and #6

10PC 45 Corn/Pellet Stove
3-90-02686R29_05/14
Venting
#5 Installing into an existing replace chimney
Thismethodprovidesexcellentventingfornormaloperation.
This method also provides natural draft in the event of a
powerfailure.
InsomeplacesintheUSandCanada,itisrequiredthatthe
ventpipeextendallthewaytothetopofthechimney.Check
withyourlocalcodes.
Inthismethodacapshouldalsobeinstalledonthechimney
tokeepoutrain.Besuretouseapprovedpelletventpipe
ttings.Sealpipejointswithsiliconeinadditiontothesealing
system used by the manufacturer. Pipe size should be
increasedto4"usingthismethod.
#6 Installing into an existing chimney
Thismethodprovidesexcellentventingfornormaloperation.
This method also provides natural draft in the event of a
powerfailure.
InsomeplacesintheUSandCanada,itisrequiredthatthe
ventpipeextendallthewaytothetopofthechimney.Check
withyourlocalcodes.Thepipeorlinerinsidethechimney
shouldbe4"diameter.
Inthismethodacapshouldalsobeinstalledonthechimney
tokeepoutrain.
Fig. 13
Fig. 14