Harman PF-120 - Ignition Cycles

Harman® • PF-120 Owner’s Manual_R3 • 2014 -___ • 10/1412
3-90-08120c
D. Ignition Cycles
1. Atthebeginningofeachignitioncycle,itisnormaltosee
somesmokeintherebox.Thesmokewillstoponcethe
restarts.
2. Thedistributionblowerwillautomaticallyturnonafteryour
fanlimitcontrolhasreachedthesettemperature.
Thisblowertransfersheatfromyourappliancethrough
yourduct.In“Automatic”modehowever,theblowerwill
turnonandoffin accordance to what temperature the
fanlimitcontrolisreadingintheplenum.Whenthewall
controlissatisedtheblowerwillshutdownuntilthewall
controlseesademandforheat.
3. Occasionallytheappliancemayrunoutoffuelandshut
itselfdown.Whenthishappens,theunitwillneedtobe
turnedtotheoffpositionandrestarted.
Ifneeded,followtheinstructionsinSectionA, “Starting
YourFirstFire”.
WARNING
!
Fire Risk
DoNOToperateappliance:
• With fuel-loading or ash-removal doors
open.
• Burnpotooropen.
• Cleaningslideplatesopen.
DoNOTstorefuel:
• Closer than required clearances to
combustiblestoappliance
• Within space required for loading or ash
removal.