EasyManua.ls Logo

Harman PF-120 - Burnpot Cleaning and Maintenance

Harman PF-120
34 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Harman® • PF-120 Owner’s Manual_R3 • 2014 -___ • 10/1417
3-90-08120c
E. Burnpot Maintenance
Whencleaningtheburnpotusethesuppliedallenwrench
toremoveanybuild-upthatmayhaveaccumulatedinthe
holesoftheburnpotgrate.Makesurealltheholesareopen
andfreefromencrustedcarbonaroundtheedges.
Aspecialeffortshouldbemadetocleanthebottominside
corners ofthe burnpot where the augertube enters the
burnpot.Carbondepositscanbuildupovertimeinthisarea
thatcould cause a restriction tothe ow ofpellets and/or
causethepelletstopushontotheburngrateareaunevenly.
Thethreeverticalcutsintheburnpotsurface(Figure5.4)
aretheretorelieveexpansionstressdotothehighheatthe
materialsees.Someunevennessmayoccurinthisarea.As
longastheholesarekeptcleanandclearofanyblockage
thiswillnoteffecttheoperationoftheunit.
Removing the swing out burnpot:
• Makesuretheunitiscooleddownorcold.
• Removeashpan.
• Swingthelatchhandleupuntilyoufeelitcontactthetop
oftheswingplate.Thenpushupwarduntilyouseethe
burnpotswingout.Figure5.5.
• Lifttheburnpotupoffoftheswingplateintheunit.
• Removetheameguide.
• Emptyanynesthatmayhavebuiltupundertheburn
potgrate.Todothisloosenthe2thumbscrewslocated
onthefrontoftheburnpotandremovethecover.The
airchamber canbecleaned of anyashthat hasfallen
throughtheholesduringoperationandcleaning.Figure
5.6
Before replacing the swing out burnpot:
1. Inspecttheredsiliconegasketonthebackoftheburnpot
tomakesurethereisnodamageorcarbonaroundthe
edgesthatmaycauseapoorseal.Figure5.7.
2. Inspectthesealingsurfaceontheswingplateinsidethe
unit.Thesurfaceneedstobecleanandsmooth.
3. Do not forget to reinstall the ame guide or the
cleanout cover.
4. Make sure the burnpot is fully seated with the latch
handledownasfarasitcango.
Figure 5.4
Vertical cuts
Pulluponhandle
Figure 5.5
Burn pot hinge/Swing plate
Figure 5.7
Red silicone gasket
Thumb screws
Figure 5.6

Other manuals for Harman PF-120

Related product manuals