Harman XXV - Avoiding Smoke and Odors; Outside Air Installation

Harman® •  Owners anualR2 • 200 - • 0811 0 3 -9 0 -0 0 6 8 4 c
E. Before Y our F irst F ire
1. irst, make sure your appliance has been properly
installed and that all safety requirements have been met.
Pay particular attention to the re protection and venting
instructions.
2. ouble check that the ash pan and rebox are empty
. Close the front door.
ire Hazard.
eep combustible materials, gasoline
and other ammable vapors and liquids
clear of appliance.
E. G eneral Operating Information
1 . R oom Sensor Calls F or Heat
The appliance is like most modern furnaces when the room
sensor calls for heat, your appliance will automatically light
and deliver heat.
When the room is up to temperature and the room sensor is
satised, the appliance will shut down.
2 . Heat Output Controls
The appliance will turn on and off as the room sensor
demands. When the room sensor calls for heat, the appliance
will always start up on High. After burning approximately 7-10
minutes, the appliance will then burn at the rate at which it
was originally set. If the appliance is set at one of the lower
settings, it will run quieter but take longer to heat up an area
than if it were set at a higher burn rate.
Regardless of the burn rate, when the area is warm enough
to satisfy the room sensor, the appliance will shut off.
W AR NING
!
• o NOT store ammable materials in the appliances vicinity.
• NEER USE GASOLINE, GASOLINE-TYPE LANTERN
UEL, EROSENE, CHARCOAL LIGHTER LUI, OR
SIILAR LIUIS TO START OR RESHEN UP A IRE
IN THIS HEATER. EEP ALL SUCH LIUIS WELL AWAY
RO THE HEATER WHILE IT IS IN USE.
• O NOT BURN GARBAGE OR LAABLE LUIS SUCH
AS GASOLINE, NAPHTHA OR ENGINE OIL.
• O NOT USE CHEICALS O LUIS TO START THE
IRE.
• Combustible materials may ignite.
F igure 3 .1