Harman® • Owners anualR2 • 200 - • 0811 1 3 -9 0 -0 0 6 8 4 c
B. F ire Characteristics
A properly adusted re has a medium active ame pattern
that extends out of the burn pot approximately inches
(152mm).
C. F eed R ate Adj ustment Instructions
The feed adustment control is factory set at #, and should
be adequate for most fuels.
However, if the flame height is too high or too low, you will
need to adust the feed rate. Wait until the appliance has been
burning for 15 minutes before making your adustments and
a
llow 15 minutes for feed adustment to take effect.
A. Starting Y our F irst F ire
1. A room sensor is required for proper operation of this
appliance in Room Temp mode. At this time, ll the
hopper with pellets, insure the control is set to O.
igure .2. Plug the power cord into a properly grounded,
nearby outlet.
2. Once power is present, the unit it will run through a quick
diagnostics test to insure the control is operating properly.
This is normal.
. or your rst re it may be necessary to purge the auger
system by putting the feed aduster knob to Test prior
to starting the unit. igure .. This insures that plenty of
fuel enters the burn pot for proper ignition.
. lip toggle switch to desired mode auto or manual. igure
.. Set feed aduster knob to desired setting and turn
mode dial to Room Temp or Stove Temp igure .5.
Note: eed rate of # is a good starting point. Adustments
made need to be made depending on fuel quality andor
heat output desired.
5.
The fuel feed system and the igniter should
now
be on.
. Once the appliance has ignited, let it burn for approximately
7-10 minutes. After this time the unit should begin to
operate per the settings at the control.
F igure 4 .5
Odors and vapors released during initial operation.
• Curing of high temperature paint.
• Open windows for air circulation.
Odors may be irritating to sensitive individuals.
CAUTION
F igure 4 .2 F igure 4 .3
F igure 4 .4
4
Operating Instructions
To Next Page
Loading...
