Harman XXV - Venting into Existing Chimney

Harman® •  Owners anualR2 • 200 - • 0811 2 3 -9 0 -0 0 6 8 4 c
D. Ignition Cycles
1. At the beginning of each ignition cycle, it is normal to see
some smoke in the rebox. The smoke will stop once the
re starts.
2. The distribution blower will automatically turn on after your
appliance has reached the set temperature.
This blower transfers heat from your appliance into the
room, and will continue to run in stove temp mode at
the set speed you have the control knob at. In room
temp mode however, the blower will turn on and off
in accordance to what temperature the room sensor is
reading. When the room sensor is satised the blower will
shut down until the room sensor sees a demand for heat.
. Occasionally the appliance may run out of fuel and shut
itself down. When this happens, the unit will need to be
turned to the off position and restarted.
If needed, follow the instructions on page 1 1 , Starting
Your irst ire.
ire Risk
o NOT operate appliance:
• With appliance door open.
• Burnpot oor open.
• Cleaning slide plates open.
o NOT store fuel:
• Closer than required clearances to combustibles
to appliance
• Within space required for loading or ash
removal.
W AR NING
!