Harman XXV - Automatic Ignition ESP Control

Harman® •  Owners anualR2 • 200 - • 0811 6 3 -9 0 -0 0 6 8 4 c
F . Manual Ignition (Continued)
The  Pellet Stove is capable of manual operation. This
also allows the operator to manually control operation during
an emergency (i.e. igniter failure, when using a 512H battery
backup, or when using certain generators.)
The unit can be switched between AUTO and ANUAL
at any time during operation.
Igniter Switch to " MANUAL"
R oom Temperature Mode
The re will have to be lit with starting gel and a match, or
started automatically, see Automatic Operation. Turn to
anual position once the start cycle begins.
The difference between AUTO Room Temperature ode
and anual Room Temperature ode is that the re will not
go out as the room temperature goes above the control board
setting. The unit can only go to low burn and will remain there
until it runs out of fuel or until more heat is needed and the
feed rate increases. eed rate adustments and dial settings
are the same as AUTO settings.
Igniter Switch to " MANUAL"
Stove Temperature Mode
The advantage of this mode is to allow the operator to have
a large viewing re without blowing extra heat into the room.
uring operation, with the temperature dial set at # or less,
the distribution fan will not operate. A # on the temperature
dial and a # on the feed aduster is approximately 80
output. It is not necessary to operate the distribution blower
below this point. Therefore, there can be a higher feed rate
(a larger viewing re) without an excess of hot air blowing
into the room.
An example of when to use the anual Stove Temperature
ode is if you want to watch a large re and the room is
already up to temperature. The Stove Temperature ode
allows you to have a larger re and a lower sound level,
without the distribution blower.
NOTE: During the use of this mode, if you keep increasing
te temperature a ettn t ncreae te re e te
distribution blower will automatically come on when the
ESP Temperature reaches 3 5 0
°
F , or 8 1 % output.
NOTE: W hen starting the unit in the " AUTO" mode
and switching to " MANUAL" , you may switch at any
time. Once an ignition cycle is started, it will continue
regardless of mode.
Room Temperature Mode: Thissettingwillproducearoomtemperature
of70degreeswiththedistributionbloweratmediumspeed.
Thissettingwillproducealargeviewingrewithouta
distributionbloweroperating.
Manual Stove Temperature Mode