14221-1850-4000
33
6.5 TOOLS REQUIRED
The following tools are recommended to complete the installation. Where specific vendor names and
model or part numbers are given, equivalent substitutes may be used:
• Non-Insulated Crimp Tool: Thomas & Betts
®
WT-111-M
• Phillips
®
-Head Screwdrivers, #1 and #2
• Flat-Blade Screwdrivers, ⅛-inch & ¼-inch tips
• Insulated Terminal Crimp Tool: Klein 1005
• 3-Millimeter Allen Wrench or Hex Bit
• Titan 11955 Ratcheting Heat Shrink Terminal
Crimper (or Equivalent)
• 7-Millimeter Hex Socket or Socket Bit
• 3-Blade Coax Cable Stripper for RG-58 Cable
similar to Tyco Electronics 1490490-1
(includes blades)
• ⅛-Inch Hex Key Wrench (Allen Wrench)
•
5
/
16
-Inch Combination or Open-End Wrench
(Only Needed for GPS Receiver Option)
• Ratcheting Hex-Crimp Tool for 50-Ohm TNC
and BNC RF Connectors and RG-58 Cable
similar to Tyco Electronics 58433-2 (includes
Crimper 354940-1 and Die Set 58436-1) or
Emerson
®
Network Power 24-9960P
• ¾-Inch or ⅜-Inch Hole Saw with Depth
Protection: ¾-Inch = Ripley HSK 19 or
Antenex HS34; ⅜-Inch = Antenex HS38
• Non-Metallic Fish Tape, 25-Foot: Klein-Lite
50156
• Clutch-Type Cordless Drill with Drill Bits and
Driver Bits
• Deburring Tool (for ⅜-inch and smaller holes)
• Flush-Cut and Large Wire Cutters
• Various Socket and Driver Sets
• Various Fasteners (e.g., machine screws and
nuts, Tek screws, etc.)
• Soft-Jaw Pliers: Tessco
®
450520 or equivalent
• Tie Wraps: Nylon, 6-inches or larger
To Next Page
Loading...
