Harris RF-7800W-OU49 series User Manual

PUBLICATION NUMBER: 10514-0426-4220
FEBRUARY 2016
Rev. -
This information is controlled by the U.S. Department of Commerce Export Administration Regulations 15
CFR 730-774, ECCN EAR99. Information contained herein is property of Harris Corporation and may not be
copied or reproduced by any means, without prior written permission.
RF-7800W-OU49x
MULTIMISSION HCLOS
RADIO
INSTALLATION/
OPERATION
MANUAL

Harris RF-7800W-OU49 series Specifications

General

Brand	Harris
Model	RF-7800W-OU49 series
Category	Radio
Language	English

Summary

CHAPTER 1 – GENERAL INFORMATION

1.1 Introduction to the RF-7800W Radio

Manual scope and intent for radio installation and operation.

1.2 System Description and Capabilities

Overview of radio capabilities, frequency range, and key features.

1.3 Equipment Description and Dimensions

Radio housing, electronics, dimensions, mounting patterns, and weight.

1.4 Specifications

Technical specs including general, wireless, network, security, and mechanical.

1.5 FCC Notices and Compliance

FCC compliance, installation, RF exposure, and user notices.

CHAPTER 2 – SYSTEM INSTALLATION

2.1 Installation Introduction and Considerations

Pre-installation factors: environment, link availability, config, co-location.

2.2 Installation Requirements

Tools and materials needed for installation.

2.3 Pre-Installation Configuration

Steps to configure radios before permanent installation.

2.4 Installation Procedures

Hardware installation, cable connection, and antenna alignment.

CHAPTER 3 – SYSTEM ADMINISTRATION AND CONFIGURATION

3.1 Introduction to System Management

Overview of GUI, CLI, and SNMP interfaces for management.

3.2 General Radio Configuration

Information on radio ports and basic configuration settings.

3.3 Navigating User Interfaces

How to use GUI, CLI, and SNMP for radio management.

3.4 Network Interface Configuration

Settings for IP addressing, subnet masks, and gateways.

3.5 Management Interfaces

Configuring HTTP, HTTPS, CLI, Telnet, SSH, and SNMP.

3.6 Wireless Interface Configuration

Settings for system mode, frequency, channel width, security, and interference.

3.7 Subscriber Links Management

Adding, configuring, and monitoring subscriber links.

3.8 Maintenance Procedures

Scripting, security files, spectrum sweep, firmware upgrades, logs, and reboots.

CHAPTER 4 – TROUBLESHOOTING AND MAINTENANCE

4.1 Introduction to Troubleshooting

Procedures for fault isolation and preventive maintenance.

4.2 Troubleshooting Procedures

Steps for factory reset, network, and wireless troubleshooting.

4.3 Preventive Maintenance Guidelines

Guidelines for scheduled care and inspection to prevent failure.

CHAPTER 5 – SUPPORT DOCUMENTATION

5.1 Introduction and Additional Support

Reference data and services for system support.

5.3 Parts Lists and Components

Lists of units, cables, hardware, antennas, connectors, and optional features.

APPENDIX A - GLOSSARY

A.1 Glossary of Terms

Definitions of terms used throughout the manual.