3-35
RF-7800W
SYSTEM ADMINISTRATION AND CONFIGURATION
3.10.9 Test
An Administrator can temporarily test the configuration before saving it permanently. This is done by entering
“Test” mode and applying (but not saving) settings. This can be useful if the desired configuration change could
result in dropping communication to a radio that is being configured. For example, changing the maximum transmit
power of a radio from over its active link could result in the link dropping. By testing the configuration, a
misconfigured radio link would return at the end of the test period.
3.10.10 Factory Defaults Reset
If desired, an Administrator can return a radio to its factory default settings in order to provide a fresh starting point
for configuration.
To Next Page
Loading...
