2-4
RF-7800W
SYSTEM INSTALLATION
2.4 INSTALLATION
2.4.1 Hardware Installation
a. Mounting the Radio
The radio's ancillary kit comes with a bracket that is designed to mount the radio and an antenna to a
vertical pipe or mast with a diameter of 1.5 to 4.0 inches. The radio can be mounted on either side of
the bracket but should be installed with the Ethernet port facing the ground (see Figure 2-1). 7/16” tools
(Items 1 & 2) are needed to assemble the bracket and install the radio.
b. Mounting the Antenna
Most of the antennas designed for use with the radio will mount to the front portion of the mounting
bracket. Support for other mounting styles like a vertical whip antenna can be achieved by swapping
out the front bracket with another design. The antenna bracket that comes in the ancillary kit is designed
to tilt the antenna through 45° of elevation about the horizon.
c. Lightning Protection (recommended)
Cables running down from equipment that is mounted on a roof, tower, or portable mast system provide
a path for lightning to surge into other equipment on the premise. A properly grounded lightning
protector installed at the bottom of the mast or at the entrance to a building can protect both personnel
and other equipment from damage due to lightning.
To Next Page
Loading...
