HART HLPM03 40V User Manual

13 – English
TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM POSSIBLE CAUSE SOLUTION
Handlenotinposition. Handle adjustment knobs and/or
handlelockleversarenotsecured.
Makesurehandleadjustmentknobsare
fully seated and handle lock levers are
fullylocked.
Mowernotstarting. Batteryislowincharge.
Startkeynotinstalled.
Handleassemblyisnotinoperating
position.
Mowerisinaverticalpositionortilted
atananglegreaterthan45º.
Themetallock(s)onthegrasscatcher
ormulchingplugisnotfullyseated
intheslot(s)onthemowerhousing.
Chargethebattery.
Installstartkey.
Makesurethehandleassemblyisinthe
operatingposition.
Placethemowerinahorizontalposition.
Gentlypushdownonthemetallock(s)to
ensureitisfullyseatedintheslot(s).
Mowercuttinggrassunevenly. Lawnisroughorcuttingheightnot
setproperly.
Adjustthecuttingheight.
Mowernotmulchingproperly. Wet grass clippings sticking to the
undersideofthedeck.
Waituntilthegrassdriesbeforemowing.
Mowerhardtopush. High grass, rear of mower housing
andbladedragging inheavygrass,
orcuttingheighttoolow.
Raisecuttingheight.
Mowernotbaggingproperly. Cuttingheightsettoolow. Raisecuttingheight.
Mowervibratingathigherspeed. Bladeisunbalanced,excessivelyor
unevenlyworn.
Bentmotorshaft.
Replacetheblade.
Stopthemotor,removestartkeyandbat-
tery.Inspectfordamage.Haverepaired
by an authorized service center before
restarting.
Motorstopswhilecutting. Cuttingheightsettoolow. Raisethecuttingheight.

HART HLPM03 40V Specifications

General

Brand	HART
Model	HLPM03 40V
Category	Lawn Mower
Language	English