9
Using External Control Pedals
You can connect external control pedals to the CTRL IN jack to allow for more hands-free control during
your performance.
Note: For best results it is recommended to use a momentary pedal.
To connect an external control pedal to the HL77, plug the external pedal into the HL77 CTRL IN jack
of the HL77. Do not press the pedal for at least 1 second so that the HL77 can recognize the pedal.
Stop Press the external pedal once to stop during recording, overdubbing and playback. This
is the same function as double-pressing the HL77 footswitch.
Tap Tempo Press the external pedal repeatedly to set the tempo while the HL77 is not playing a loop.
Clear Loop Press and hold the external pedal to clear all of the recordings that have not been saved.
You can connect two external pedals using a “Y” cable or a two button pedal to the HL77.
When using two external pedals, the left pedal provides the above functions. The second pedal will
perform the following functions:
PATTERN UP Short press the external pedal.
PATTERN DOWN Press the external pedal twice within 1 sec.
To Next Page
Loading...