COMPUTER OPTIONS AND INSTRUCTIONS
EB-1 9
BUTTON FUNCTIONS
MODE:
Press to select function, and hold for 4 seconds for a total reset.
FUNCTIONS
SCAN
TIME Displays total working time up to 99:59 minutes.
Automatically scans through each function at intervals of 6 seconds.
SPEED
Displays the current speed up to 99.9 km/h or ml/h. The value will stay on the moni-
tor continuously.
DISTANCE Displays total working distance of up to 99.99 km or ml from zero.
CALORIES Displays calorie consumption during exercise. Maximum value is 9999 calories.
(This data is a rought guide for comparison of dierent exercise sessions and should
not be used as a basis for medical treatment)
1. To nish workout, press “STOP” sign on the upper-left corner of the monitor.
2. If there is no signal for a period of 4 minutes, the display will shut down automatically
with all function values stored.
3. Turn on the monitor by pressing the button or by pedaling.
4. If monitor display is not working properly, please try reinstalling the batteries.
5. Battery Spec: 1.5V UM-3 or AA (2 pcs)
1. Changing the batteries. To change the computer batteries, please slide the computer from the
computer holder, remove the battery cover on the back of the computer console, and remove the
batteries. Replace with 2 x AA batteries. Finally, put the cover back on the console, and slide the
computer back on the holder.
2. Computer not working correctly. If your computer is not working correctly, please check
whether the computer sensor wire is plugged into the computer. If you have checked the above
and the computer is still not working, then please make sure the batteries are still working and that
they are installed correctly in the computer.
3. No resistance. If there is no tension resistance, please turn the tension adjustment knob to its
lowest level, and then go to the friction belt buckle which is located on top of the fan wheel
beneath the center beam. Loosen the friction belt, pull it through the buckle until you can feel
some resistance on the belt, and then lock it back around the buckle. Now mount your Elliptical
Bike and turn the pedals. If you nd it is now too tight, go back to the friction belt buckle and
loosen the belt slightly.
NOTE:
TROUBLESHOOTING
To Next Page
Loading...
