Hasbro Bop It! Maker User Manual

matey
INFORMATION
TO
REPLACE
BATTERIES
batteries
with
A
AAA
Replace
demo
rea
DAT
eA
TERIES
REQUIRED
alkaline
batteries.
Use
a
Phillips/cross
head
screwdriver
(not
included).
IMPORTANT:
BATTERY
INFORMATION
Z\
CAUTION:
1.
As
with
all
small
batteries,
the
batteries
used
with
this
Swallowed,
promptly
see
a
doctor
and
have
the
doctor
your
local
poison
control
center.
2.
TO
AVOID
BATTERY
LEAKAGE
a.
Always
follow
the
instructions
carefully.
Use
only
batteries
specified
and
be
sure
to
insert
them
correctly
by
matching
the
+
and
—
polarity
chlo
b.
Do
not
mix
old
batteries
and
new
b
i
atteries
or
standard
(carbon-zi
ine
batteries
.
Remove
exhausted
or
dead
batteries
from
the
product.
—
Cc
a
Remove
batteries
if
product
is
not
to
be
played
with
for
a
long
time.
f
small
children
who
still
put
things
in
their
mouths.
If
they
are
ame sh from
: cast bate f you reside outside the United States, have the doctor call
phone (202) 625-3333 collect. |
.
Do
not
short-circuit
the
supply
terminals.
.
RECHARGEABLE
BATTERIES:
Do
not
mix
these
with
any
other
types
of
batteries.
Always
remove
from
the
product
before
recharging.
Recharge
batteries
under
adult
supervision.
DO
NOT
RECHARGE
OTHER
TYPES
OF
BATTERIES.
3.
Should
this
product
cause,
or
be
affected
by,
local
electrical
interference,
move
it
away
from
other
electrical
equipment.
Reset
(switching
off
and
back
On
again
or
removing
and
reinserting
batteries)
if
necessary.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However,
there
is
no
guarantee
that
interference
will
not
occur
in
a
particular
installation.
If
this
equipment
does
cause
harmful
interference
to
radio
or
television
reception,
which
can
be
determined
by
turning
the
equipment
off
and
on,
the
user
is
encouraged
to
try
to
correct
the
interference
by
one
or
more of the following measures:
Reorient
or
relocate
the
receiving
antenna.
;
Increase
the
separation
between
the
equipment
and
receiver.
Consult
the
dealer
or
an
experienced
radio/TV
technician
for
help.
Caution:
Changes
or
modifications
to
this
unit
not
expressly
approved
by
the
party
responsible
for
compliance
could
void
the
user's
authority
to
operate
the equipment.
CAN ICES-3 (B) / NMB-3 (B)
U.S. Pat No. 60864
©
2016
Hasbro
Pawtuckst,
Ri
02861-1059.
USA
All
Rights
Reserved
TM
&
@
denote
U.S.
Trademarks.
78
Consumer comtact
USA and Canada: Hasbro Games. fe Park, NSW 2113, Australia. TEL. 1 200
Hast Asta Lm Ei 7 Abany Hiway, Mand, New Zexiand TEL 0508 628 20 HASBROGAMING'COM
A EASY STEPS TO GET GOING FAST!
@ Create your custom move! Turn the dial settings
to slot 1 and follow the prompts. Add your
move name, motion, and sound effect. (For full
instructions, turn the page!)
Now turn the dial settings to SOLO mode, and
BOP IT to start.
Follow the commands as quickly and accurately
as you can.
@ See how long you can keep up to reach the
highest score.
SHOUT IT
directly into the microphone
RED LIGHT
lights up when recording
STAR SLOT/BASIC GAME
BOP {T
to start (tapping firmly!), after
selecting SOLO (a), PARTY (sa),
or BASIC (%*«) game.
SQUEEZE IT
and hold down to record
in slots 1-10
ROLL IT
to adjust volume after selecting
VOLUME on the dial. Cycle through
QUIET, LOUD, or BLASTING.
(The volume defaults to the LOUD
Setting, or the last setting played,
if you do not select a volume level.)
CUSTOM MOVE STORAGE )-®
Select a numbered slot to RECORD a new move,
TEST a recorded move, or ERASE a recorded move.

Hasbro Bop It! Maker Specifications

General

Product Type	Electronic Game
Age Range	8 years and up
Recommended Age	8+
Number of Players	1 or more players
Batteries Required	Yes
Manufacturer	Hasbro
Battery	3 AAA batteries
Product Dimensions	10.5 x 7.5 x 2.5 inches
Features	Create your own Bop It! game with customizable sounds and commands

Summary

Battery Information and Safety

Battery Replacement

Instructions for replacing demo batteries with alkaline ones using a screwdriver.

Battery Handling Precautions

Safety guidelines for handling small batteries, preventing leakage, and dealing with interference.

FCC Compliance Statement

Interference Correction Measures

Measures to correct potential radio or TV reception interference caused by the device.

Game Unit Overview

Dial Settings Explained

Explanation of dial settings like SOLO, PARTY, BASIC, and VOLUME controls.

Custom Move Storage

How to record, test, or erase custom moves in numbered slots.

Creating Custom Moves

Custom Move Components

Details the three parts required for a custom move: name, motion, and sound effect.

Recording a Custom Move

Step-by-step guide on recording the name, physical action, and sound effect for custom moves.

Proper Game Unit Handling

Playing the Game

Solo Game with Custom Moves

How to play the solo mode using custom moves, responding to commands.

Party Game with Custom Moves

Instructions for the party mode, passing the unit, and playing with others.

Solo Basic Game without Custom Moves

How to play the solo mode using the basic game commands without custom moves.

Testing and Erasing Custom Moves

Playing Tips and Tricks

Reducing Custom Moves

Advice on reducing the number of custom moves if you're having trouble keeping up.

Copying Custom Moves Accurately

Emphasizes accurate copying of custom moves for correct recognition by the game.

Custom Move Inspiration

Move Ideas

Provides examples and suggestions for creating fun and safe custom moves for the game.