Haswill STC-8080H - Adjusting Parameter Values; Saving Configuration; Forced Defrosting Operation

https://www.thermo-hygro.com
3 / 4
key to change the value;
Step4
Release all keys once it reaches your aim value;
Repeat operation from Step 2 / 3 / 4 to adjust
other parameters;
Step5
After configuring all values, press the key to
save data and back to normal monitor status.
Attention: the modified value will be saved
automatically and back to normal status if
without operation in 30 seconds.
4. Run the Forced Refrigeration
Hold the key for 3s to start the forced-defrosting mode;
do it again to stop defrosting.
More Tips:
This unit controls the defrosting only by the time, but not by
the evaporator temperature like STC-9100.