Hatco GLO-RAY GR User Manual (English)

Questions and Answers:

M
Mary HowellJul 30, 2025
What to do if Hatco GLO-RAY GR Heater unit is turned on but there is no heat?
- E
  Emily ScottJul 30, 2025
  If your Hatco Heater isn't producing heat when turned on, consider these potential causes: * **No power to the unit:** Check the circuit breaker and reset it if necessary. Inspect the power cord for any damage. Also, verify the power outlet is functioning correctly. * **Defective switch:** Check both the input and output sides of the switch for power. If there's power on the supply side but none on the output side, the switch needs replacement. * **Open wiring:** Check for power at the heating element. If there's no power, inspect the wiring for breaks or bad connections, and repair or replace as necessary. * **Defective heating element:** Check the heating element for continuity using an ohm meter to check the element's resistance. Replace the heating element if it is defective.
N
Nancy WilliamsAug 6, 2025
Why is my Hatco GLO-RAY GR Heater heat inadequate?
- A
  Anne DavisAug 6, 2025
  If the heat from your Hatco Heater is inadequate, here are some possible reasons: * **Unit mounted too high:** Lower the unit to bring the effective heat closer to the target area. * **Excessive air movement:** Restrict or redirect air movement (e.g., from air conditioning ducts or exhaust fans) away from the heater's target area. * **Incorrect power supply:** Check the power supply to the unit, ensuring it matches the rating on the unit. If the power supply is incorrect, change it to match the unit's rating.
M
Mr. Brandon GarciaAug 14, 2025
What to do if Hatco GLO-RAY GR Heater heat is excessive?
- W
  Warren JonesAug 14, 2025
  If the heat output from your Hatco Heater is excessive, consider the following: * **Unit mounted too close:** Ensure the installation adheres to the specifications for your specific type/model. If it's too close, increase the mounting height. * **Voltage supply too high:** Check the power supply to the unit to ensure it matches the unit's rating. Correct the power supply if it's incorrect.
T
Thomas GrossAug 22, 2025
How to prevent Hatco GLO-RAY GR control switches from burning out rapidly?
- B
  Brittany PenaAug 22, 2025
  Rapid burn-out of control switches in your Hatco Heater can be due to: * **Switches mounted in the heat zone:** Check the switch location against Hatco guidelines in the Glo-Ray Installation and Operations Manual. If incorrectly installed, relocate the switches to a cooler zone. * **Non-Hatco switches used:** Replace any aftermarket or generic switches with genuine Hatco parts, as these are designed for safe and proper operation within the unit's environment.