Form No. TPTM-0712
8
MAINTENANCE
General
The Pop-Up Toaster is designed for maximum durability and
performance with minimum maintenance.
ELECTRIC SHOCK HAZARD:
• Unplug power cord and allow unit to cool before
performing cleaning, adjustments, maintenance, or
attempting to clear a jam.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• This unit is not “jet-proof” construction. Do not use jet-
clean spray to clean this unit.
• Do not steam clean or use excessive water on unit.
• Do not allow liquids to spill into unit.
• Unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
This unit has no “user-serviceable” parts. If service is
required on this unit, contact an Authorized Hatco Service
Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350; fax 800-690-2966; or
International fax 414-671-3976.
NOTE: Submerging or saturating the unit with water will
damage the unit and void the unit warranty.
Cleaning
To preserve the finish of the toaster, it is recommended that the
metal surfaces be wiped daily with a non-abrasive, damp cloth.
ELECTRICSHOCKHAZARD: Do not clean unit when it is
energized or hot.
1. Unplug the power cord and allow the unit to cool.
2. Remove and empty the crumb trays. CAUTION! BURN
HAZARD—Do not remove crumb trays for cleaning until
toaster is cool.
3. Wash the crumb trays with warm water and a mild
detergent. Rinse with water.
4. Allow the crumb trays to air dry or hand dry with a soft cloth
before placing back into the toaster.
5. Wipe the exterior surface of the toaster with a damp cloth.
NOTICE: Use non-abrasive cleaners and cloths only.
6. Wipe dry with clean, dry, non-abrasive cloth.
To Next Page
Loading...
Need help?
General
