Hatz 1B30V - Starting Procedures

When adding oil or checking the oil level, the
engine must be horizontal.
6
– Remove oil filler screw „1“ and dipstick „2“.
7
– Add engine oil up to the MAX mark on dip-
stick.
Lubricating oil capacity: see Chapter 3.1.
– Insert the oil filler screw and tighten it (hand-
tight only).
4.1.2. Fuel
Stop the engine before refilling the fuel
tank. Never refuel near a naked flame
or sparks which could start a fire.
Don’t smoke. Use only pure fuel and clean
filling equipment. Take care not to spill fuel.
All diesel oils which satisfy the following specifi-
cations are suitable:
EN 590 or
BS 2869 A1 / A2 or
ASTM D 975 -1D / 2D
8
– Before the first start or if the fuel tank has
been run dry, completely fill the fuel tank with
diesel. The bleeding of the fuel system is auto-
matically.
At temperatures below 0 °C, winter-grade fuel
should be used or paraffin added to the fuel well
in advance.
Lowest ambient
temperature when
starting, in °C
Paraffin content for:
Summer Winter
fuel fuel
0 up to –10 20 % –
–10 up to –15 30 % –
–15 up to –20 50 % 20 %
–20 up to –30 – 50 %
10