Hatz 1B30V - Servicing: Once a Year; Draining the Fuel Tank

41
– Check joint washer „1“ whether it is damage;
replacement if necessary.
– Check joint washer „2“ whether it is damage
and correctly fitted, replace oil filter if
necessary.
– Lubricate joint washer before fitting.
42
– Put in oil filter and press until limit stop.
– Check whether tension springs sit close to oil
filter with both ends „1“, before tightening
screw.
– Check the dipstick oil level and, if necessary,
add oil to the max. mark, Chapter 4.1.1.
5.6. Servicing: once a year
5.6.1. Draining the fuel tank
When working on the fuel system, do
not expose it to a naked flame;
do not smoke.
– Condensation forms due to temperature varia-
tions at the lowest points of the fuel tank.
The condensate must therefore be removed once
a year as follows:
43
– Fit a polyethylene tube ( diameter 4 mm,
length approx. 350 mm) to a commercial
syringe (20 ml or larger).
27