EasyManua.ls Logo

Hatz 1B30V - Engine Operation Procedures; Pre-Start Procedures and Checks

Hatz 1B30V
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
For any offer as well as spare parts orders it is
necessary to mention the following data (also
see spare parts list, page 1):
engine type / spec.
(only for special equipment)
engine number
max. engine rated speed
Attention:
If the engine was certified for constant-speed
application and shall be used so, the field “con-
stant-speed only” is marked with “X”.
If the engine was certified for variable speed ap-
plication and shall be used so, the field “variable
speed” is marked with “X”.
Always install the engine for its intended applica-
tion in order to comply with EPA and CARB
emission regulation requirements.
Label 2/2
3b
The engine must be operated with “LOW SUL-
FUR FUEL OR ULTRA LOW SULFUR FUEL
ONLY”.
The label also states the applicable emission-
related power category of the engine.
EMISSION CONTROL INFORMATION
LOW SULFUR FUEL OR
ULTRA LOW SULFUR FUEL ONLY
Power category:
< 8 kW / 8-19kW / 19-37kW /
37-56 kW PM Standard: 0.3 g/kWh
Label 2/2
Fuel label
3c
The fuel label is placed nearby the fuel inlet.
If there was no fuel tank mounted to the engine,
the label has to be permanently attached to the
equipment near the fuel inlet.
4
Engine serial number on crankcase.
LOW SULFUR FUEL OR ULTRA
LOW SULFUR FUEL ONLY
8

Related product manuals