EasyManuals Logo

Haulotte Group HTL 4010 User Manual

Haulotte Group HTL 4010
248 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #195 background imageLoading...
Page #195 background image
195
2420344510 E 11.11 AUS
Telescopic handlers
H
- Lubrication and maintenance
8 - Every day or every 10 h of operation
8.1 - GENERAL CHECKS
Perform a visual check for any leaks (Check the corresponding reservoir fluid level if leak is detected).
Check that there are no signs of scratches, tears and warping on the hoses, accessories and work
tools.
Check the attachment devices and the hydraulic connections.
Check the appearance of the mechanical parts.
Check the operation of the controls, control indicator lights and other system indicators.
Check diesel engine operation : Check the colour of the exhaust fumes and locate any abnormal
noises.
Check and clean the radiator's protection grill.
Check the state of the anti-slip parts (cab access steps) and replace them if necessary.
Check that the tires are not damaged after the first 10 hours and then after every 100 h of operation.
Check the wheel lug nut torque ( 300Nm) after the first 10 hours and then after every 100 of
operation.
8.2 - LOAD MOMENT INDICATOR
The load moment indicator's function is to constantly monitoring the stability of the front of the
machine. To check that it is functioning correctly, proceed as follows :
Without any payload on the machine, retract the boom fully and level it.
Level the chassis.
Press the test button on the load moment indicator display.
All of the LEDs should flash and a warning signal should sound. This indicates that the system is
working properly.
Check the tire inflation pressure : 4,5 bar(65,2 psi) minimum (For HAULOTTE® tyres, code : 2326014870
or 232601508).
During a pressure check or an inflation operation, always face the end of the tyre; never face the side of
the tyre.
Do not allow contact with abrasive materials.
Do not raise the boom during this test.
If the test gives a different result then it is indicating a fault in the system the machine must be removed
from service and the fault identified and fixed before putting the machine back into service.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Haulotte Group HTL 4010 and is the answer not in the manual?

Haulotte Group HTL 4010 Specifications

General IconGeneral
BrandHaulotte Group
ModelHTL 4010
CategoryExcavators
LanguageEnglish

Related product manuals