To Next PageTo Next PageWhat to do if my Hayward AQR100 shows 'Low Input Power'?
If your Hayward Inverter indicates 'Low Input Power', remove power to the AQR100 for two minutes and then re-apply. Verify that the AQR100 input power wiring is correct. Make sure that there is adequate input voltage.
How to troubleshoot a 'Cell Error' on my Hayward AQR100 Inverter?
To troubleshoot a 'Cell Error' on your Hayward Inverter, first, remove power to the AQR100 for two minutes and then re-apply. Inspect the cable that connects the cell to the system, ensuring it is secure and undamaged.
What does it mean when the 'PROBLEM DETECTED' LED is illuminated AND the 'MAX' LED is blinking on my Hayward AQR100?
When the 'PROBLEM DETECTED' LED is illuminated AND the 'MAX' LED is blinking, check that the Cell cap is properly plugged in and that the wire to the Control Box is not cut or damaged.
What should I do if my Hayward Inverter displays 'Internal Error'?
If your Hayward Inverter displays an 'Internal Error,' first remove power to the AQR100 for two minutes and then re-apply. Check that the salt level in the pool is no greater than 4500 ppm and/or the temperature does not exceed 104ºF.
General
