To Next PageTo Next Page
Need help?Do you have a question about the Hayward AquaRite S3 Series and is the answer not in the manual?
General| Model | AquaRite S3 Series |
|---|---|
| Pool Size | Up to 40, 000 gallons |
| Salt Requirement | Yes |
| Salt Level | 2700-3400 ppm |
| Chlorine Output | Up to 1.45 lbs/day |
| Warranty | 3 years |
| Voltage | 120/240 VAC |
| Flow Switch | Yes |
| Type | Salt Chlorination System |
Compliance information regarding Federal Communications Commission (FCC) rules.
Compliance information regarding Canadian industry standards (ICES-003).
Lists the essential components packaged with the AquaRite S3 system.
Lists additional items required for a complete installation of the AquaRite S3.
Guidelines for mounting the AquaRite S3 unit and temperature sensors.
Instructions for plumbing the flow switch and electrolytic cell in the return line.
Instructions for connecting the AquaRite S3 to control heaters via low voltage dry contacts.
Wiring instructions for pool/spa and air temperature sensors.
Connecting a pool cover sensor for automatic adjustments to chlorination and pump speed.
Sealing the enclosure, connecting the flow switch, and installing the TurboCell.
Recommendations for the type of salt to use and the procedure for adding it to the pool.
Using buttons, setting language, time, and unit preferences for the AquaRite S3.
Configuring cell type, pump, heater, and sensor connections for the AquaRite S3.
Procedure for downloading and installing the latest firmware for the AquaRite S3 unit.
Accessing and adjusting chlorination levels, Super Chlorination, and diagnostics.
Setting desired chlorine levels and configuring pump speeds and modes.
Setting daily operating schedules for pump activation, including times and speeds.
Adjusting heater setpoint, extending operation, and configuring cool-down cycles.
Configuring pool cover detection for automatic adjustments to chlorination and pump speed.
Customizing display properties, time settings, and unit preferences in the AquaRite S3.
Viewing system information and accessing service settings for advanced configuration and diagnostics.
Setting cell type, pump speeds, body of water, and other system configuration items.
Managing connected devices, performing resets, and viewing service mode status.
