To Next PageTo Next Page
Need help?Do you have a question about the Hayward AquaRite AQRS325OMNI and is the answer not in the manual?
General| Product Type | Salt Chlorine Generator |
|---|---|
| Model Number | AQRS325OMNI |
| Automation | Yes |
| Voltage | 120/240V |
| Warranty | 3 years |
| Connectivity | Wi-Fi |
| Flow Rate | 20 GPM minimum |
| Cell Type | Turbo Cell |
| Power Supply | Digital |
| Control Type | Digital |
| Salt Range | 2700-3400 ppm |
Sensor for heater control, installed in plumbing after filter.
For recirc freeze protection, mounted outdoors with low thermal conductivity.
Connection for powering the AquaRite S3 unit from the main panel.
Connections for sensors, VSP, Smart Relay, heater, and flow switch.
Hayward 10K ohm thermistor sensors for pool/air temperature measurement.
Sealing the low voltage exit with foam gasket and re-installing the panel.
Recommended levels for salt, pH, alkalinity, and hardness for pool sanitization.
Indicator of water balance relating calcium and alkalinity, affecting corrosion or scaling.
Adding and maintaining the correct salt level for chlorine generation.
Initial setup wizard for pool equipment, language, time, and units.
Details on the Home Screen, quick adjustments for chlorination and heater settings.
Setting up the AquaRite S3 to operate under an Omni automation control or Master unit.
