To Next PageTo Next Page
Need help?Do you have a question about the Hayward C-SPA-XI 11 and is the answer not in the manual?
General| Heater Type | Electric |
|---|---|
| Voltage | 240V |
| Heating Capacity | 11 kW |
| Maximum Flow Rate | 40 GPM |
| Warranty | 1 year |
Explains safety symbols and lists relevant industry standards.
Details risks like hair, limb, body entrapment and mechanical entrapment, plus reduction measures.
Warns about hazards from system pressure and potential separation of components.
Warns about electric shock hazards from wiring, grounding, and bonding requirements.
Details risks of hyperthermia from hot water, effect on children, pregnant women, and medication users.
Guides on inspecting for damage, warranty void conditions, and heater placement.
Outlines factors like filtration, circulation, disinfection, and pH control for optimal operation.
Details technical specs like BTU, KW, AMP ratings, wire size, and dimensions for different models.
Specifies minimum piping size (1.5" I.D.) and rules for valve installation in water lines.
Details electrical connection requirements, wiring standards, and GFCI recommendations for safe installation.
Instructs on cleaning filters, starting the pump, and purging air before system operation.
Describes setting the thermostat, the function of the pilot lamp, and adjusting temperature incrementally.
Details the function of the pressure switch and how to adjust it for different installation heights.
Illustrates pressure switch settings for below and above spa surface installations based on water depth.
Addresses two-speed pump operation and prevents dry-firing of heating elements.
Provides steps to check filter, pump, and indicator lights if the heater fails to produce heat.
Warns about chemical misadjustment causing corrosion and provides guidelines for chemical use.
Advises on draining the heater to prevent freeze damage when shut off in cold temperatures.
Alerts users to the harm of chemical vapors and advises against storing chemicals near the heater.
Describes the automatic shutoff due to overheating and how to reset the high limit.
Explains the importance of adequate water flow for operation and lists recommended flow rates.
Outlines the one-year warranty for defects and lists exclusions like improper maintenance and water chemistry.
