EasyManuals Logo

Hayward ColorLogic User Manual

Hayward ColorLogic
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
WARNING - Read and follow all instructions in this owner’s manual and on the equipment. Failure
to follow instructions can cause severe injury and/or death.
WARNING – Suction Entrapment Hazard Suction in suction outlets and/or suction outlet
covers which are, damaged, broken, cracked, missing, or unsecured can cause severe injury and/
or death due to the following entrapment hazards:
Hair Entrapment- Hair can become entangled in suction outlet cover.
Limb Entrapment- A limb inserted into an opening of a suction outlet sump or suction outlet cover
that is damaged, broken, cracked, missing, or not securely attached can result in a mechanical bind
or swelling of the limb.
Body Suction Entrapment- A negative pressure applied to a large portion of the body or limbs can
result in an entrapment.
Evisceration/ Disembowelment - A negative pressure applied directly to the intestines through
an unprotected suction outlet sump or suction outlet cover which is, damaged, broken, cracked,
missing, or unsecured can result in evisceration/ disembowelment.
Mechanical Entrapment- There is potential for jewelry, swimsuit, hair decorations, finger, toe or
knuckle to be caught in an opening of a suction outlet cover resulting in mechanical entrapment.
WARNING - To Reduce the risk of Entrapment Hazards:
When outlets are small enough to be blocked by a person, a minimum of two functioning
suction outlets per pump must be installed. Suction outlets in the same plane (i.e. floor or
wall), must be installed a minimum of three feet (3’) [1 meter] apart, as measured from near
point to near point.
Dual suction fittings shall be placed in such locations and distances to avoid “dual blockage”
by a user.
Dual suction fittings shall not be located on seating areas or on the backrest for such seating
areas.
The maximum system flow rate shall not exceed the flow rating of as listed on Table 1.
Never use Pool or Spa if any suction outlet component is damaged, broken, cracked, missing,
or not securely attached.
Replace damaged, broken, cracked, missing, or not securely attached suction outlet compo-
nents immediately.
In addition two or more suction outlets per pump installed in accordance with latest ASME,
APSP Standards and CPSC guidelines, follow all National, State, and Local codes applicable.
Installation of a vacuum release or vent system, which relieves entrapping suction, is recom-
mended.
WARNING – Failure to remove pressure test plugs and/or plugs used in winterization of the pool/
spa from the suction outlets can result in an increase potential for suction entrapment as described
above.
WARNING – Failure to keep suction outlet components clear of debris, such as leaves, dirt, hair,
paper and other material can result in an increase potential for suction entrapment as described
above.
WARNING – Suction outlet components have a finite life, the cover/grate should be inspected
frequently and replaced at least every ten years or if found to be damaged, broken, cracked, miss-
ing, or not securely attached.
CAUTION – Components such as the filtration system, pumps and heater must be positioned so
as to prevent their being used as means of access to the pool by young children. To reduce risk of
injury, do not permit children to use or climb on this product. Closely supervise children at all times.
Components such as the filtration system, pumps, and heaters must be positioned to prevent chil-
dren from using them as a means of access to the pool.
WARNING – Hazardous Pressure Pool and spa water circulation systems operate under
hazardous pressure during start up, normal operation, and after pump shut off. Stand clear of
circulation system equipment during pump start up. Failure to follow safety and operation instruc-
tions could result in violent separation of the pump housing and cover, and/or filter housing and
clamp due to pressure in the system, which could cause property damage, severe personal injury,
7
USE ONLY HAYWARD GENUINE REPLACEMENT PARTSUSE ONLY HAYWARD GENUINE REPLACEMENT PARTS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hayward ColorLogic and is the answer not in the manual?

Hayward ColorLogic Specifications

General IconGeneral
TypeLED
Lens MaterialPolycarbonate
Voltage12V
Housing MaterialPolymer
CertificationUL Listed
Color OptionsMultiple (customizable light shows)

Related product manuals