USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
13
Manual Override
During normal operation, the pump speed can be manually overridden for 3 hours by a quick press and release of the button.
Manual Override Speeds
There are 3 speeds available in manual override mode:
• HIGH
• MED
• LOW
• STOP
To cycle through the speeds press the button additional times while in override mode. Manual override mode will always start at HIGH.
Note: Initiating override mode will not change the start time for the daily schedule. While in override mode, the pump will operate at a single speed for 3 hours
and then will revert back to normal operation according to the daily schedule. This does not apply to the STOP function and the pump will remain stopped until
manual override is cancelled or a manual override speed is selected.
Manual Override Example
If the daily schedule started at 8:00AM, and the daily schedule was Speed 1 - 4 hours, Speed 3 - 8hours, and STOP – 12 hours. Pressing the button for
manual override at 7:00PM would result in a 3 hour override from 7:00PM-10:00PM and when completed, the schedule would resume in Interval 3, which is
programmed as STOP. The start of the daily schedule remains at 8:00AM.
INTERVAL 1
SPEED1
INTERVAL 2
SPEED3
INTERVAL 3
(STOP)
8:00 AM
HIGH
START OVERRIDE
RESUME SCHEDULE
3 HOURS
The manual override mode can also be canceled by pressing and holding the button for 4 seconds while override mode is active. This will cause the pump to
resume the daily schedule in the same manner as if the manual override expired.
Changing between Operating Modes
Operating Mode Button Press Action
Normal Operation Quick Press Start manual override
Manual Override
Quick Press Change manual override speeds
Press and Hold 4 seconds Exit manual override
OVERRIDE MODE - 3 hours
To ENTER
Press once
To EXIT
Press & Hold
HIGH
3 hours
MEDIUM
3 hours
LOW
3 hours
STOP
No time limit
Press for next speed
Light flashes slowly in
OVERRIDE MODE
4 second hold
To Next Page
Loading...
