To Next Page
S
Sally AndradeJul 27, 2025
What to do if my Hayward OmniLogic Lighting Equipment wired Ethernet shows “MSP Not Found”?
- LLaura KelleyJul 27, 2025
If you're seeing an “MSP Not Found” error with your Hayward Lighting Equipment's wired Ethernet connection, here are a few things to try: * If the OmniLogic system hasn't been set up yet, either load a backed-up file or finish the configuration. * Make sure your firmware is up-to-date. * Check that the Ethernet cable is firmly plugged into your router or modem and that it’s not in a PoE or WAN port. * Test the Ethernet cable with a LAN tester to confirm it's working correctly. * Try switching the Ethernet cable with another one on your router to see if that helps. * Ensure your router is assigning IP addresses using DHCP. * Reboot your router and modem, wait about three minutes, and then test again.
General
