EasyManua.ls Logo

Hayward Power-Flo Matrix SP15932S User Manual

Hayward Power-Flo Matrix SP15932S
13 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
ISSP1591
Rev. D
_________________________________________________________________________________
OWNER’S MANUAL
INSTALLATION, OPERATION, & PARTS
Power-Flo Matrix
Pump Series
The Hayward Power-Flo
®
Matrix™ Pump Series is specifically engineered for the demanding requirements of today’s above-
ground swimming pools. The advanced design reduces maintenance requirements while providing superior performance.
To prevent potential injury and to avoid unnecessary service calls, read this manual carefully and completely.
CAUTION We highly recommend a qualified professional install and service this product.
WARNING This manual contains important safety information that must be furnished to the end
user of this product. FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS COULD RESULT
IN SERIOUS INJURY.
*Only units equipped with 3'
twist-lock cords are UL-listed.
SAVE THIS INSTRUCTION MANUAL
HAYWARD POOL PRODUCTS, INC.
Corporate Headquarters: U.S.A:
620 Division Street 1 Hayward Industrial Drive 2935 Sidco Drive 2875 Pomona Blvd.
Elizabeth, NJ 07207 Clemmons, NC 27012 Nashville, TN 37204 Pomona, CA 91768
Canada: Europe:
2880 Plymouth Drive P.I. Plaine de l'ain
Oakville, Ontario L6H 5R4 Allêe des chênes
01150 St Vulbas France
Question and Answer IconNeed help?

Do you have a question about the Hayward Power-Flo Matrix SP15932S and is the answer not in the manual?

Hayward Power-Flo Matrix SP15932S Specifications

General IconGeneral
ModelSP15932S
TypeSwimming Pool Pump
Horsepower1.5 HP
Voltage115/230V
Flow Rate60 GPM
Service Factor1.0
Pump TypeSelf-Priming
Port Size1.5 inches
Wet End MaterialThermoplastic
Discharge Size1.5 inches
Suction Size1.5 inches
Amps15/7.5 A

Summary

IMPORTANT SAFETY INSTRUCTIONS

Product Specifications

Dimensions

Technical drawings and measurements of the pump.

Installation Instructions

Pump Location

Guidance on selecting an optimal location for pump installation.

Pump Mounting

Plumbing

Electrical

New Installation – Start-Up & Operation

Prior to Start-Up

Preparatory steps and safety checks before initial operation.

Selecting Pump's Discharge Position

Priming Pump

Shaft Seal Change Instructions

Troubleshooting

Motor Will NOT START – Check For:

Common causes and checks when the motor fails to start.

Pump Won't Prime

Maintenance

Replacement Parts

Parts Diagram

Visual representation of pump components and their numbering.

HAYWARD® LIMITED WARRANTY

Related product manuals