Hayward Super Pump User Manual

WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
P/N: ISSPSERIES
REV. A
__________________________________________________________________________________________
OWNER’S MANUAL
INSTALLATION, OPERATION, & PARTS
*50HZ Models are not UL or CSA Listed.
Super Pump
™
Series
The Hayward Super Pump
TM
is specifically engineered for the demanding requirements of today’s in-ground swimming pool/spa that
is equipped with large capacity filters, heaters, and pool cleaning equipment. The Super is a self-priming pump that incorporates an
improved seal and impeller design that will provide many years of efficient, dependable, corrosion-free service. The advanced design
provides superior performance while reducing maintenance requirements.
To prevent potential injury and to avoid unnecessary service calls, read this manual carefully and completely.
WARNING – This product should be installed and serviced only by a qualified professional.
CAUTION – A licensed electrician MUST complete, in full, all electrical installations noted in this manual.
SAVE THIS INSTRUCTION MANUAL
Use of non-Hayward replacement parts voids warranty.
ATTENTION
INSTALLER – THIS MANUAL CONTAINS IMPORTANT INFORMATION ABOUT THE
INSTALLATION, OPERATION, AND SAFE USE OF THIS PUMP THAT MUST BE FURNISHED TO THE END USER
OF THIS PRODUCT. FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS COULD RESULT IN SERIOUS
INJURY.
HAYWARD POOL PRODUCTS, INC.
620 DIVISION STREET ELIZABETH, NJ 07207 (908) 351-5400
WWW.HAYWARDPOOL.COM

Hayward Super Pump Specifications

General

Brand	Hayward
Model	Super Pump
Category	Swimming Pool Pump
Language	English

Summary

Owner's Manual: Installation, Operation & Parts

Important Safety Instructions

Child Safety and Supervision

Pump Usage Restrictions

Electrical Wiring and Grounding Safety

Electrician Responsibilities and Wiring Codes

Mandates licensed electricians for all wiring, conforming to local/national codes.

Ground Fault Circuit Interrupter (GFCI) Installation

Requirement for a licensed electrician to install a GFCI for safety.

Pump Bonding for Electrocution Prevention

Emphasizes bonding the pump to the pool structure to prevent electrocution.

Suction Entrapment Hazard Warnings

Details on various entrapment hazards: hair, limb, body, evisceration, mechanical.

Reducing Entrapment Risks

Guidelines for installing multiple suction outlets and their spacing to prevent entrapment.

Installation Instructions and Guidelines

Professional Installation Requirement

Plumbing and Electrical Setup

Electrical Wiring Compliance

Mandates licensed electricians for all wiring, adhering to codes and using proper wire size.

Motor Grounding and Bonding

Crucial steps for grounding the motor and bonding all metal parts to prevent shock.

Electrical System Details and Operation Start-Up

Grounding and Bonding Procedures

Pump Priming and Operation Safety

Instructions to fill strainer housing with water and warnings against running pump dry.

Storage and Shaft Seal Replacement

Shaft Seal Replacement Safety

Safety precautions and instructions for qualified personnel performing seal replacement.

Troubleshooting Common Issues

Motor Will Not Start Diagnosis

Checks for wiring, rotation, and timer issues when the motor fails to start.

Motor Shuts Off Diagnosis

Troubleshooting low voltage or thermal overload protector issues.

Motor Hums, No Start Diagnosis

Pump Priming Problems

Low Flow and Noisy Pump Troubleshooting

Low Flow Diagnosis

Noisy Pump Diagnosis

Hayward Limited Warranty Information