EasyManua.ls Logo

Hayward TriStar SP3007EEAZ User Manual

Hayward TriStar SP3007EEAZ
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
P/N: IS3200
Rev. D
__________________________________________________________________________________________
OWNER’S MANUAL
INSTALLATION, OPERATION, & PARTS
*50HZ Models are not UL Listed.
TriStar
Pump Series
The Hayward TriStar Pump is specifically engineered for the demanding requirements of today’s in-ground swimming pool/spa that is
equipped with large capacity filters, heaters, and pool cleaning equipment. The TriStar is a self-priming pump that includes an
improved seal and impeller design that will provide many years of efficient, dependable, corrosion-free service. The advanced design
provides superior performance while reducing maintenance requirements. NOTE - To prevent potential injury and to avoid
unnecessary service calls, read this manual carefully and completely.
SAVE THIS INSTRUCTION MANUAL
HAYWARD POOL PRODUCTS, INC.
620 DIVISION STREET ELIZABETH, NJ 07207 (908) 351-5400
WWW.HAYWARDPOOL.COM
TriStar Pump Replacement Guide
TriStar
TriStar Super II Super II
Model No. Model No. Model No. Model No.
Full Rated Max Rated Full Rated Max Rated
--- SP3207X10 SP3007EEAZ SP3007X10AZ
SP3207EE SP3210X15 SP3010EEAZ SP3010X15AZ
SP3210EE SP3215X20 SP3015EEAZ SP3015X20AZ
SP3215EE SP3220X25 SP3020EEAZ SP3020X25AZ
SP3220EE SP3225X30 SP3025EEAZ SP3025X30AZ
SP3230EE --- --- ---
IMPORTANT – READ CAREFULLY
NOTE - The TriStar is a high performance, high
efficiency pump. When replacing most existing
pumps, you can use a TriStar pump with a lower
horsepower rating than the existing pump.
Required: 2” plumbing minimum
Recommended: 2 ½” plumbing or larger
Question and Answer IconNeed help?

Do you have a question about the Hayward TriStar SP3007EEAZ and is the answer not in the manual?

Hayward TriStar SP3007EEAZ Specifications

General IconGeneral
Horsepower1.5 HP
Voltage115/230 V
Warranty1 Year
Port Size2 inches
PhaseSingle
SpeedSingle Speed
Wet End MaterialThermoplastic
Connection Size2 inches
TypeSwimming Pool Pump

Summary

Important Safety Instructions

General Safety Warnings and Precautions

Covers essential safety warnings, cautions, and hazard alerts for operating the pump.

Electrical Wiring and Bonding Requirements

Suction Entrapment Hazards

Reducing Entrapment Risks

Provides instructions and standards to mitigate risks associated with suction entrapment.

Operational Hazards and Warnings

General Information

Introduction and Product Benefits

Introduces the pump series and outlines its key features and advantages.

Product Specifications

Installation Instructions

Pump Location and Mounting

Guides on selecting an optimal location and securely mounting the pump for efficient operation.

Plumbing and Electrical Requirements

Plumbing Guidelines

Details on using Teflon tape, fitting selection, and pool/spa plumbing standards.

Electrical Wiring Standards

Covers motor wiring, voltage matching, and wire/breaker requirements.

Electrical System Details

Voltage, Grounding, and Wiring

Explains voltage considerations, grounding/bonding practices, and circuit wiring requirements.

Start-Up and Operation Procedures

Pre-Start Checks and Pressure Testing

Outlines essential checks and procedures before initial pump operation, including pressure tests.

Pump Starting and Priming

Priming Steps and Cautions

Provides step-by-step instructions for priming the pump and critical cautions to follow.

Maintenance Guidelines

Routine Maintenance Tasks

Details on cleaning strainer baskets, keeping the motor clean, and seal lubrication.

Storage and Winterization

Winterization Procedures

Instructions for draining the pump and piping, and storing the unit to prevent freeze damage.

Shaft Seal Replacement Procedures

Safety and Motor Removal

Safety precautions and steps for removing the motor assembly for seal replacement.

Shaft Seal Replacement (cont'd.)

Impeller, Diffuser, and Seal Installation

Steps for installing the impeller, diffuser, and new shaft seal components.

Motor Assembly Reassembly

Guidance on reassembling the motor assembly to the pump housing.

Replacement Parts Overview

Parts Diagram and Listing

Visual diagram and a list of all replacement parts with their corresponding part numbers.

Replacement Parts Details

Pump Model and Part Cross-Reference

Details specific impeller and motor part numbers for different pump models.

Troubleshooting Common Issues

Motor and Priming Issues

Diagnoses and solutions for problems like the motor not starting or the pump not priming.

Troubleshooting (cont'd.)

Flow Rate and Pump Noise

Addresses issues related to low water flow and noisy pump operation.

Limited Warranty Information

Warranty Registration and Policy

Outlines the product warranty terms, conditions, and registration process.

Related product manuals