Need help?Do you have a question about the Hayward Sense and Dispense AQL-CHEM and is the answer not in the manual?
General| Brand | Hayward |
|---|---|
| Model | Sense and Dispense AQL-CHEM |
| Category | Lighting Equipment |
| Language | English |
Hazardous voltage can shock, burn, cause serious injury and or death. To reduce risk, use qualified technicians and ensure grounding.
Covers compatibility with controls, water flow verification, recalibration, and comprehensive water chemistry testing.
Details recommended residential/commercial schedules and indicators like slow response or inconsistent readings.
Probes must be kept clean and wet; acid feed tubing requires annual replacement for proper function.
Includes disconnecting, removing, cleaning probe tips, and reinstalling probes.
Guides through accessing the wizard, entering values, adjusting pH, and saving the calibration.
Guides through accessing the wizard, entering values, adjusting pH, and saving the calibration.
Instructions for ProLogic and Aqua Rite Pro to locate and clear the 'pH/ORP Timeout - Chk Feedr' error.
Inspect the CSM cable for damage and verify its connection to the main circuit board.
Measure CSM board voltage and verify flow cell location to diagnose CSM Comm Error.
Verify probe terminal connections and inspect connector cleanliness to resolve probe errors.
Test pool and flow cell pH, and inspect the pH reduction feeder's operation.
Clean the pH probe, run the system, and recalibrate using the wizard to resolve the error.
Check pH reduction circuit voltage and verify CO2 release for AQL-CHEM2 units.
Test pool and flow cell pH levels and clean the flow cell with dish soap.
Check the status of the CO2 tank or Stenner pump to ensure proper function.
Analyze pool chemistry, specifically free chlorine and Cyanuric Acid (CYA) levels.
Clean the pH probe, run the system, and recalibrate to address the 'pH High' error.
Test pool and flow cell pH levels and clean the flow cell with dish soap.
Check the status of the CO2 tank or Stenner pump to ensure proper function.
Clean the pH probe, run system, and extend the pH feed timeout setting.
Clean the pH probe, run system, and recalibrate using the wizard to resolve the error.
Check free chlorine levels and identify if chlorine reducers are being used.
Clean the flow cell and the ORP probe, then run the system to check readings.
Measure chlorine levels and clean the flow cell with dish soap.
Clean the ORP probe and run the system for 120 minutes to check readings.
Measure chlorine levels and adjust the ORP Timeout setting and Chemistry Extend.
Compare pool/cell size with run times and clean the ORP probe.
To Next Page