Hayward Pro Logic User Manual

Automation and Chlorination
Operation Manual
for models
PL-PS-4 PL-PS-8-V
PL-PS-8 PL-PS-16-V
PL-PS-16
Quarterly Monthly Weekly
Free Chlorine 1.0 - 3.0 ppm
pH 7.2 - 7.8
Raise desired output % to
increase, lower desired output %
to decrease -OR- increase or
decrease pump filtration time.
Too low - add soda ash.
Too high - add muriatic acid
Alkalinity 80 - 120 ppm
Salt 2700 - 3400 ppm Add salt as required to increase.
Add baking soda to increase.
Stabilizer 60 - 80 ppm Add cyanuric acid to increase.
Calcium 200 - 400 ppm Add calcium to increase.
Electrolytic Cell inspect & clean Refer to section in manual.
TEST IDEAL RANGE ADJUSTMENT REQUIRED
Drain and add water to decrease.
Add acid as required to decrease.
Pro Logic
092331D RevF
Copyright © 2010 Hayward
www.haywardnet.com
620 Division St.
Elizabeth, NJ 07207

Hayward Pro Logic Specifications

General

Type	Automation Controller
Expandability	Yes
Display	LCD
Housing Material	Plastic
Connectivity	Wired and Wireless Options
Voltage	120V/240V
Beam Angle	N/A (Controller, not a light)
Installation Type	Wall-mounted
Control Compatibility	Hayward Equipment
Salt Chlorination	Optional (with Salt Cell)

Summary

IMPORTANT SAFETY INSTRUCTIONS

READ AND FOLLOW ALL INSTRUCTIONS

General safety instructions to read and follow for proper operation and safety.

LIMITED WARRANTY

WARRANTY EXCLUSIONS

Details specific conditions not covered by the warranty terms.

System Overview

Automation

Explains Pro Logic's ability to control pool equipment and remote operation.

Chlorination

Manual System Operation

Pool Filter Pump

Details manual operation of the pool filter pump.

Lights and Aux Outputs

System Off

System Off

Service

Service

How to enter and exit service or service-timed modes.

Diagnostic Menu

Diagnostic Menu

System Maintenance

Servicing and Cleaning the Turbo Cell

Instructions for cleaning the electrolytic cell.

Settings Menu

Spa Heater 1

Pool Heater1

Spa Chlorinator

Pool Chlorinator

Timers Menu

Start/Stop Superchlorination

Group Function

Configuration Menus

Chlor. Config.

Configuration settings for the chlorinator.

Cell Type Selection

Chlorinator

Cell Type Selection

Filter Config.

Filter Pump

Aux1 Group

Spa Filter Config.

Spa Filter Pump

Lights Config.

Heater1 Config.

Solar Config.

Solar

Pool/Spa Setup

Salt Level

Troubleshooting & Diagnostic Information

Service Mode

How to enter and exit service or service-timed modes.

Check System Indicator

Automatic System Operation

Warranty

Pro Logic Warranty