Need help?Do you have a question about the Hayward ProLogic and is the answer not in the manual?
General| Category | Lighting Equipment |
|---|---|
| Display | LCD |
| Connectivity | Wired and Wireless |
| Voltage | 120V/240V |
| Color Temperature | N/A (Controller, not a light) |
| Beam Angle | N/A (Controller, not a light) |
| Material | Plastic |
Description of ProLogic system capabilities and features for pool control.
Detailed diagram and component identification for the ProLogic main printed circuit board.
Steps to restore the ProLogic system to its factory default settings.
Procedure for resetting the average salt level in the ProLogic system.
Instructions for adjusting the chlorinator output percentage for salt chlorination.
Guide to setting the Oxidation-Reduction Potential (ORP) set point for Sense & Dispense.
Steps to verify and change the installed cell type in the ProLogic system.
Procedure to clear the 'Inspect Cell' message on the ProLogic system.
Detailed instructions on how to clean the Hayward TurboCell.
Comparison of Stock Keeping Units (SKUs) for ProLogic and AquaLogic systems.
Diagnosing and resolving issues with no cell power or low voltage.
Steps to troubleshoot a blank display or missing LEDs on the ProLogic unit.
Resolving communication errors related to the Chemistry Sensing Module (CSM).
Diagnosing chlorinator off status due to high salt or amperage.
Steps to resolve communication errors 1 and 2 in the ProLogic system.
Diagnosing and fixing issues when the heater fails to operate.
Resolving problems with auxiliary equipment not activating.
Chart showing cell compatibility with different ProLogic control center models.
Chart correlating resistance or voltage to temperature for air/water sensors.
Guide for determining the amount of salt required for different pool sizes.
Explanation of cycle time, super-chlorinate function, and salt level readings.
Information on how to interpret ProLogic system serial numbers.
To Next Page