To Next PageTo Next Page
Need help?Do you have a question about the Hayward Pro Logic PL-PS-8 and is the answer not in the manual?
General| Brand | Hayward |
|---|---|
| Model | Pro Logic PL-PS-8 |
| Category | Water Filtration Systems |
| Language | English |
General instruction to read all safety guidelines before use.
Instruction to retain safety instructions for future reference.
Explains how the Pro Logic controls pool equipment automatically.
Explains generic and custom names for system outputs.
Instructions for manually operating the pool filter pump.
How to manually control lights and auxiliary equipment.
Controls for pool and spa valves to switch between modes.
Operation of pool and spa heaters.
How to turn off all system outputs.
How to enter service or service-timed modes.
Explains the use of keypad buttons for programming.
Adjusts desired spa temperature and heater settings.
Adjusts desired pool temperature and heater settings.
Configures priority for dual heaters.
Adjusts spa and pool solar temperatures.
Configures speeds for variable speed pumps.
Controls the super chlorination function.
Adjusts chlorinator output for pool and spa.
Sets high and low speeds for variable speed pumps.
Configures ColorLogic settings for Aux1.
Sets day/time, display light, and beeper options.
Guides on teaching and configuring wireless remotes.
Sets programmed on/off times for the filter pump.
Sets programmed times for filter pump T2 and onward.
Sets programmed on/off times for spa operation.
Programs timeclocks and countdown timers for lights.
Sets programmed times for spa filter pump operation.
Programs timeclocks and countdown timers for Aux1.
Programs timeclocks and countdown timers for valves.
Sets the duration for superchlorination.
Sets alternate heater temperatures when groups are active.
Details on Super Chlorinate and Variable Speed within groups.
Settings for enabling and configuring the chlorinator.
Guides setting up chemistry sensing and chlorination.
Configures pool/spa modes and valve assignments.
Sets up heater functions and priorities.
Configures spa count down and spillover settings.
Manages filter operation and valve changes.
Sets filter name, pump speed, flow, and freeze protection.
Configures spa filter pump, freeze protection, and external input.
Detailed settings for Heater1 and Heater2.
Settings for solar heating controls.
Settings for ColorLogic lights and external inputs.
Settings for lights relay, function, interlock, and groups.
Interlock, freeze protection, and pump speed for lights.
Settings for Aux1 output, including relay type and function.
Interlock, freeze protection, and pump speed for Aux1.
Configuration for virtual aux outputs on specific models.
Settings for Valve3, including name, function, and interlocks.
Group, external input, freeze protection, and pump speed for Valve3.
Setup for 6-button spa side remotes.
Mapping buttons on spa remotes to Pro Logic functions.
Configuration for remote menu access and time/unit formats.
Procedures for pH calibration and probe cleaning.
Step-by-step guide for manual spa control.
How to set up automatic spa schedules.
Setting spa and pool heater temperatures.
Adjusting the chlorinator output level.
How to start and stop superchlorination cycles.
Setting up timeclock schedules for outputs.
Setting up countdown timers for outputs.
Entering and exiting service modes.
Overview of essential water chemistry parameters.
Recommended levels for various pool water chemicals.
Explains how to calculate and interpret the saturation index.
Guidelines for adding and maintaining salt levels.
Recommends salt types and how to add salt.
Instructions for cleaning the electrolytic cell.
Steps to take before freezing temperatures.
Guide for restarting the system in spring.
How to use service mode for manual control.
Explains the "Check System" LED and common errors.
Navigating the diagnostic menu for system data.
