Hayward SP1580 User Manual

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 1
PowerFlo LX
™
/ PowerFlo II
™
/ EP
Pump Series
Owner’s Manual
INSTALLATION, OPERATION, & PARTS
IMPORTANT SAFETY INSTRUCTIONS
Hayward Pool Products
620 Division Street, Elizabeth, NJ 07207
Phone: (908) 355-7995
www.haywardnet.com
Contents
Product Warnings……….………2
Installation……….……………..…4
Start-Up & Operation…….…….6
Shaft Seal Replacement……….7
Troubleshooting…………………..8
Replacement Parts………..….…10
Warranty …………………………..…11
Registration………………………….12
ISPFSERIES Rev G
Basic safety precautions s
h
ou
ld
a
l
ways
b
e fo
ll
owe
d
, inc
l
u
d
ing t
h
e fo
ll
owing: Fai
l
ure to fo
ll
ow instructions can
cause severe injury and/or death.
This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for
one of the following signal words and be alert to the potential for personal injury.
WARNING warns about hazards that could cause serious personal injury, death or major property
damage and if ignored presents a potential hazard.
CAUTION warns about hazards that will or can cause minor or moderate personal injury and/or property
damage and if ignored presents a potential hazard. It can also make consumers aware of actions that are
unpredictable and unsafe.
The NOTICE label indicates special instructions that are important but not related to hazards.

Hayward SP1580 Specifications

General

Manufacturer	Hayward
Model	SP1580
Horsepower	1.5 HP
Voltage	115/230 V
Speed	Single Speed
Strainer Basket	Yes
Wet End Material	Thermoplastic
Type	Pool Pump
Material	Thermoplastic

Summary

Owner's Manual and Safety

Important Safety Instructions

Critical safety precautions to prevent severe injury or death.

Suction Entrapment Hazards

Reducing Entrapment Risks

Guidelines for installing multiple suction outlets and proper placement.

Specific Entrapment Warnings

Warnings about debris, damage, and component lifespan.

Electrical and Separation Safety

Electrical Shock Hazards

Warnings and precautions related to electrical shock and grounding.

Separation Hazard and Grounding

Covers separation hazards and essential grounding/bonding requirements.

Installation Instructions

Pump Location and Mounting

Guidelines for selecting pump location and proper mounting methods.

Plumbing and Piping

Instructions on using TFE tape and connecting piping for the pump.

Start-Up and Operation

Prior to Start-Up and Priming

Steps and precautions before initial pump operation and priming.

Storage and Winterization

Guidelines for storing the pump during off-season or freezing temperatures.

Shaft Seal Change Instructions

Safety First for Servicing

Essential safety measures before beginning shaft seal replacement.

Step-by-Step Seal Replacement

Detailed guide for replacing the pump's shaft seal.

Troubleshooting Guide

Motor and Pump Start Issues

Diagnosing and resolving problems with motor start-up and pump priming.

Flow and Operation Problems

Addressing common issues like low flow, noisy operation, and air leaks.

Maintenance Procedures

Routine Cleaning and Inspection

Instructions for cleaning the strainer basket and inspecting components.

Motor and Seal Care

Guidance on keeping the motor clean and shaft seal replacement.

Replacement Parts Information

Parts Diagram and Listing

Visual diagram and list of available replacement parts for the pump series.

Hayward Pool Products Limited Warranty

Warranty Terms and Conditions

Information on the product's limited warranty terms and conditions.

Warranty Card Registration

How to Register Your Warranty

Instructions and form for registering the product warranty online or via mail.