IMPORTANT SAFETY INSTRUCTIONS
When using this electrical equipment, basic safety precautions should always be followed, including
the following:
• READ AND FOLLOW ALL INSTRUCTIONS
• Use Copper Conductors Only
• Disconnect all AC power during installation.
• Warning - To reduce the risk of injury, do not permit children to use this product unless they
are closely supervised at all times.
• Hayward salt systems are designed, tested and sold as systems and are certified by several
agencies around the globe --- with each component of the systems meeting all required certi-
fications and attendant legal requirements. The use of an untested, uncertified generic cells (or
generic circuit boards) with Genuine Hayward salt chlorination products could lead to premature
product failure.
• Pursuant to the terms and conditions of any applicable Warranty, the use of a non-genuine
Hayward replacement salt chlorination cell on any Hayward automation or chlorination product
will void any Warranty.
• A green colored terminal marked "Earth Ground" is located inside the wiring compartment.
To reduce the risk of electric shock, this terminal must be connected to the grounding means
provided in the electric supply service panel with a continuous copper wire equivalent in size to
the circuit conductors supplying the equipment.
• One bonding lug for US models (two for Canadian models) is provided on the external surface.
To reduce the risk of electric shock, connect the local common bonding grid in the area of the
swimming pool, spa, or hot tub to these terminals with an insulated or bare copper conductor
not smaller than 8 AWG US / 6 AWG Canada.
• All field installed metal components such as rails, ladders, drains, or other similar hardware
within 3 meters of the pool, spa or hot tub shall be bonded to the equipment grounding bus with
copper conductors not smaller than 8 AWG US / 6 AWG Canada.
• NOTICE TO USERS: This control product is to be used only in accordance with the directions of
this label. It is an offense under the Pest Control Products Act to use a control product under
unsafe conditions.
SAVE THESE INSTRUCTIONS
1
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
To Next Page
Loading...
Need help?
General
