5
AED System Digital Transducer Electronics
A1780−4.3 en/de/fr/es/it HBM
Do not allow the equipment to become dirty or damp.
During installation and when connecting the cables, take action to prevent
electrostatic discharge as this may damage the electronics.
The required power supply is an extra-low voltage with safe disconnection from
the mains.
When connecting additional devices, comply with the appropriate safety re-
quirements.
Shielded cables must be used for all connections. The screen must be con-
nected extensively to ground on both sides. The power supply and digital I/O
connection cables only need to be shielded if the cables are longer than 30 m
or are routed outside closed buildings.
To Next Page
Loading...
