Need help?Do you have a question about the HBM C2 Series and is the answer not in the manual?
General| Product Type | Cable |
|---|---|
| Category | Accessories |
| Series | C2 |
| Application | Sensor connection |
| Type | Cable |
| Connector Type | BNC |
Covers general dangers, residual dangers, and environmental conditions affecting load cells.
Prohibits unauthorized modifications to the load cells and their design.
Details requirements for qualified personnel and accident prevention measures.
Notes specific safety instructions for explosion-proof load cell models.
Explains the meaning of symbols and markings used throughout the manual.
Guidelines for using shielded, low-capacitance measurement cables and avoiding interference.
Explains connection to measuring amplifiers using a six-wire circuit.
Details wiring load cells in parallel and implications for output signals.
Instructions for four-wire circuit connection and its effects.
Recommendations for extension cables and their impact on measurements.
Guidance on routing cables to prevent water ingress and damage.
Lists ATEX options and requirements for explosion-proof load cells.
Provides dimensional data for standard C2A load cells with pendulum support.
Details dimensions for the explosion-proof C2A/.../Exd load cells.
To Next Page
