Need help?Do you have a question about the HBM SK12 and is the answer not in the manual?
General| Brand | HBM |
|---|---|
| Model | SK12 |
| Category | Transducer |
| Language | English |
Table listing dimensions (ØA, ØB, ØC, ØD, E) and weight for SK5 types.
Table listing moment of mass inertia (Ix) for SK5 types.
Lists the components included in the delivery.
Defines intended use and limitations.
Outlines risks from misuse, untrained personnel, and inherent system dangers.
Specifies requirements for covers or enclosures after mounting for accident prevention.
Lists the items included in the SK5 and SK6 scope of supply.
Describes the use of slipring assemblies for transmitting measurement signals.
Explains the construction and operation of SK6/SK12 slipring heads.
Provides step-by-step instructions for mounting with a mounting plate.
Details how to mount slipring heads without using a mounting plate.
Explains solder tags and numbering for connecting measurement leads.
Advises on using full bridge circuits for strain gauge measurements.
Explains how to properly earth the rotor and stator housing.
Details the steps for replacing worn brushes.
Presents data on resistance, voltage, current, speed, shock, and vibration.
Provides dimensional drawings for the slipring head and mounting plate.
Describes the SK5 slipring body.
Explains the SK5/ZB brush holder design.
Details the steps for mounting the SK5 slipring body with the brush holder.
Advises on centering, balancing, brush contact, and keeping sliprings clean.
Describes how leads are brought out and how to secure measurement cables.
Recommends full bridge for strain gauge measurements.
Explains earthing the slipring body and brush holder.
Discusses monitoring slipring/brush wear and cleaning procedures.
Lists electrical parameters for SK5.
Lists mechanical parameters for SK5.
Provides dimensional data for the SK5 slipring body.
Lists moment of mass inertia values for SK5 types.
Lists the items included in the SK5 scope of supply.
To Next Page
