Healtech Speedohealer v4 - User Manual

SHv4_D01_InstallGuide_en.pdf [rev. 003] - 1 -
http://www.speedohealer.com
Install Guide for SH-D01 Harness Kit
For use with the following DUCATI motorcycles:
Hypermotard (2007-2010), Monster (2003-2010), Multistrada (2003-2010), ST3
(2004-2007), ST4s (2004-2005), Streetfighter (2009-2010), 749 (2003-2006), 848
(2008-2010), 999 (2003-2006), 1098 (2007-2009), 1198 (2009-2010)
Also fits MV AGUSTA F4 (2003-2010), Brutale (2004-2010)
Disclaimer:
Do not attempt to install the product if you don’t have basic mechanical skills.
The SpeedoHealer is intended to improve speedometer accuracy. However, HealTech
Electronics Ltd. and its distributors shall not be liable for any loss, damage or penalties
caused by improper installation or inaccurate speed readings.
1. Locating the Speed Sensor coupler
Preparation:
- The ignition key should be in OFF position.
- Raise the rear wheel off the ground by using a stand.
Make sure the rear wheel spins freely.
- Remove the seat.
Ducati:
The Speed Sensor is mounted at the rear wheel. Trace the cable from the
sensor until you find the 3-pole black speed sensor connector. The connector is usually
accessible by removing the right side fairing and on most models it is in close proximity
of the right side engine cover.
MV Agusta:
the connector is at the front sprocket cover.
If in doubt, check the bike’s Service Manual or ask your dealer for the location of the
Speed Sensor coupler.
Confirmation:
Separate the Speed Sensor coupler (you might need to use a small flathead screwdriver
to get the coupler apart). Rotate the rear wheel while the ignition is on.
Does the speedometer show 0, turn the ignition off and proceed to the next step.
Otherwise, try again since you have disconnected something else.

Summary

Locating the Speed Sensor Coupler

Preparation Steps

Steps to prepare for locating the speed sensor coupler, including turning off ignition and removing the seat.

Ducati Speed Sensor Location

Instructions for finding the speed sensor connector on Ducati motorcycles, usually near the engine.

MV Agusta Speed Sensor Location

Instructions for finding the speed sensor connector on MV Agusta motorcycles, located at the front sprocket cover.

Confirmation Procedure

Steps to verify correct installation by checking speedometer readings while rotating the rear wheel.

Installation Process

Connecting SH Harness

Plug in the 3-pole and 4-pole SH harness connectors and secure them to the SH box.

Installation Test

Test the SH installation by checking speedometer response during ignition ON and wheel rotation.

Mounting Location Guidelines

Criteria for selecting a suitable mounting location for the SH box, avoiding wet or hot areas.

Harness Routing

Instructions for neatly routing the SH harness along the frame, avoiding interference and stress.

Top Speed Recall Feature

Connect the remote button for the Top Speed Recall feature and route its harness.

Setup Resources

Utilize the online calculator or User's Guide for detailed setup instructions.

Healtech Speedohealer v4 Specifications

General

Adjustment Range	-99.9% to +99.9%
Resolution	0.1%
Type	Speedometer Calibrator
Compatibility	Most motorcycles with electronic speed sensors
Memory	Non-volatile memory (settings saved when power is off)
Display	LCD
Buttons	3 buttons for easy programming
Power Supply	Powered by vehicle battery
Features	shift light
Waterproof	Yes